1997 Cadillac Eldorado Owner's Manual - Page 71

When you pressthis symbol to unlock the driver's door,the parking lamps on your vehicle will blink twice. (You can program your vehicle so the parking lamps will not flash. For more information, see "Remote Confirmation" later in this section.) Pressing itagain within five seconds will unlock the other doors. Pressing this button will disarm the also optional theft-deterrent system and turn on the interior lamps at night. When you press this symbol to lock the doors, the parking lamps w l blink once. (You can programyour i l vehicle so the parking lamps will not flash. For more information, see "Remote Confirmation" laterin this section.) This also arms the optional theft-deterrent system when the ignition is off. Press this symbolto open the trunk. Press t h s button to open thefuel door. The p ( transmitter can also be used to recall. the uE memory settings for up two drivers. For more to information, see "Memory Seat and Mirrors" in the Index. Note that pressing the transmitter buttons numerous times (approximately 500 times) out of the vehicle's operating range may cause the transmitter not work. Replacing to the battery and pressing the transmitter buttons 10 or more times out range will also cause the transmitter of not to work. To reset the transmitter, you must be within the vehicle's operating range. Press and hold trunk the button, and withinone second, press andhold the lock button. Continueto hold both buttons for approximately three seconds. See your Cadillac dealer service if your for transmitter still doesn't work properly. This personalization feature allows the driver program to the parlung lamps to blink or to remain off when the lock or unlock buttons o the RISE transmitter are pressed. m Press the SET (TIRIIP RESET) button to answer "yes," press theWESET' (INFO RESET) button to indicate "no"or press the INFORMATION (INFO) button to "skip" to the next personalization feature. To begin programming, pressthe unlock button of the RKE transmitter for the appropriate driver ( 1 or 2 ) . The ignition must be in the RUN position. Press and hold the INFORMATION (INFO) and RESET (INFO RESET) buttons at the same time. The firstmessage to appear refers to the programmable automaticdoor locks. To skip this prompt, press the'I[NFQWMATION (INFO) button.