1997 Cadillac Seville Owner's Manual - Page 104

Setting the cruise control a desired speed and then at applying the brake will end the cruise function. Once you're going about 25 mph (40 k d h ) or more, vou can move the cruise Lontrol switch from ON to R/A (Resume/Accelerate) for abouthalf a second t o reset. This returnsyou to your desired preset speed. Also note that the DIC will display the CRUISE ENGAGED message again. Remember, if you hold the switch at RIA longer than half a second, the vehicle will accelerate until you release the switch or apply the brake. You could be startled and even lose control. So unless you want to go faster, don't hold the switch at R/A. There are two ways to go to a higher speed: 1. Use the accelerator pedal to go to a higher speed. Push the button at the end of the lever and then release the button and the accelerator pedal. You'll now cruise at the higher speed. 2. Move the cruise switch from ON to WA. Hold it there until you reach a desired speed and then release the switch. (To increase your speed in very small amounts, nlove the switch to R/A. Each time you do this, your vehicle will go about 1 mph ( 1.6 k d h ) faster.) The accelerate feature will only work after you have set the cruise control speed by pushing the SET CRUISE button. 2-43