2014 Cadillac Escalade Owner Manual - Page 118

5-6 Instruments and Controls CALIBRATION COMPLETE for a few seconds when the calibration is complete. The DIC display will then return to the previous menu. If auto timing is set, the time displayed on the clock may not update immediately when driving into a new time zone. To set the clock display: 1. Select Settings from the Home Page, then select Time and Date Settings. 2. Select Clock Display. 3. Turn the MENU knob to Off or On. 4. Press the MENU knob to select. Press o BACK to go to the last menu and save the changes. To calibrate the compass, use the following procedure: Compass Calibration Procedure 1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See "Compass Variance (Zone) Procedure" earlier in this section. Do not operate any switches such as window, sunroof, climate controls, seats, etc. during the calibration procedure. 2. Press the vehicle information button until PRESS V TO CALIBRATE COMPASS displays. 3. Press the set/reset button to start the compass calibration. 4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display Clock Setting the Time and Date To set the time or date: 1. Select Settings from the Home Page, then select Time and Date Settings. 2. Select the desired function. 3. Turn the MENU knob to increase or decrease the value. 4. Press the MENU knob to go to the next value. After the last value is selected the system will update and return to the Settings menu. Press o BACK to go to the last menu and save the changes. Power Outlets The accessory power outlets can be used to plug in electrical equipment, such as a cell phone or MP3 player. The vehicle has three accessory power outlets located: . Inside the floor console storage bin. On the rear of the floor console. .