2005 Chevrolet Astro Owner's Manual - Page 157

Finding a Station AM-FM: Press this knob to switch between FM1, FM2, and AM. The display will show the selection. TUNE: Turn this knob to select radio stations. Setting Preset Stations Up to 21 stations (seven FM1, seven FM2, and seven AM) can be programmed on the four numbered pushbuttons, by performing the following steps: 1. Turn the radio on. 2. Press AM-FM to select FM1, FM2, or AM. 3. Tune in the desired station. 4. Press SET. SET will appear on the display. 5. Press one of the four pushbuttons within five seconds. Whenever that numbered pushbutton is pressed, the station that was set will return. 6. Repeat the steps for each pushbutton. In addition to the four stations already set, up to three more stations may be preset on each band by pressing two adjoining pushbuttons at the same time and by performing the following steps: 1. Tune in the desired station. 2. Press SET. SET will appear on the display. 3. Press two adjoining pushbuttons at the same time, within five seconds. Whenever you press the same two pushbuttons, the station you set will return. 4. Repeat the steps for each pushbutton. o SEEK p: Press the right or the left arrow to go to the next or to the previous station and stay there. The radio will only seek stations with a strong signal that are in the selected band. o SCAN p: Press both SCAN arrows at the same time. SCAN will appear on the display. The radio will go to the next station, play for a few seconds, then go on to the next station. Press the RECALL knob or either SCAN arrow to stop scanning. The radio will only scan stations with a strong signal that are in the selected band. 3-41