2005 Chevrolet Blazer Owner's Manual - Page 137

Setting Cruise Control ON: Move the switch to this position to turn the cruise control on. R/A (Resume/Accelerate): Move the switch to this position to maintain a desired speed after braking. SET: Press this button at the end of the lever to set your desired speed. 1. Move the cruise control switch to ON. 2. Get up to the speed you want. 3. Press in the SET button at the end of the lever and release it. 4. Take your foot off the accelerator pedal. {CAUTION: If you leave your cruise control on when you are not using cruise, you might hit a button and go into cruise when you do not want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control. The cruise control system is located on the end of the turn signal/multifunction lever. Resuming a Set Speed Suppose you set your cruise control at a desired speed and then you apply the brake. This, of course, shuts off the cruise control. But you don't need to reset it. Once you're going about 25 mph (40 km/h) or more, you can move the cruise control switch briefly from ON to R/A (Resume/Accelerate). You'll go right back up to your chosen speed and stay there. OFF: Move the switch to this position to turn the cruise control off. If you hold the switch at R/A, the vehicle will keep going faster until you release the switch or apply the brake. So unless you want to go faster, don't hold the switch at R/A. 3-11