2007 Chevrolet Monte Carlo Owner's Manual - Page 151
2007 Chevrolet Monte Carlo Manual
Page 151 highlights
Headlamp High/Low-Beam Changer To change your headlamps from low beams to high beams, or from high to low, pull the multifunction lever all the way toward you. Then release it. While the high beams are on, this light will appear on the instrument panel cluster. Windshield Wipers Be sure to clear ice and snow from the wiper blades before using them. If they are frozen to the windshield, gently loosen or thaw them. Damaged wiper blades may not clear the windshield well, making it harder to see and drive safely. If the blades do become damaged, install new blades or blade inserts. For more information, see Windshield Wiper Blade Replacement on page 347. Heavy snow or ice can overload the wiper motor. A circuit breaker will stop the motor until it cools down. Clear away snow or ice to prevent an overload. You control the windshield wipers by turning the band with the wiper symbol on it. This light works only while the key is in RUN. The fog lamps (if equipped) are not illuminated when the high beams are on. Flash-to-Pass With the turn signal lever in the low-beam position, pull the lever toward you briefly to switch to high-beam, (to signal you are going to pass). If the headlamps are on, they will return to low-beam when the lever is released. This feature operates even if the headlamps are off. 8 (Mist): For a single wiping cycle, turn the band to mist. Hold it there until the wipers start. Then let go. The wipers will stop after one wipe. If you want more wipe cycles, hold the band on mist longer. 151