2008 Chevrolet Aveo Owner's Manual - Page 135

To change the current mode, select one of the following from the right knob: Y (Vent): outlets. This mode directs air to the instrument panel \ (Bi-Level): [ (Floor): Uplevel shown, Base similar, Sedan only Temperature Control: Turn the left knob clockwise or counterclockwise to manually increase or decrease the temperature inside the vehicle. Turn the knob to the blue area for cool air and to the red area for warm air. This mode directs about half of the air to the instrument panel outlets, and then directs the remaining air to the floor outlets. This mode directs most of the air to the floor outlets. Some of the air will also be directed to the rear outlets. Be sure to keep the area under the front seats clear to allow the flow of air to the rear compartment. The right knob can also be used to select the defog and defrost modes. Information on defogging and defrosting can be found later in this section. 9 (Fan): Turn the middle knob clockwise or counterclockwise to increase or decrease the fan speed. In any setting other than off, the fan will run continuously with the ignition on. The fan must be on in order for the air conditioning compressor to run. ? (Recirculation): This mode keeps outside air from coming into the vehicle. It can be used to prevent outside air and odors from entering the vehicle or to help heat or cool the air inside the vehicle more quickly. If your vehicle has a recirculation button (uplevel model), press the button to turn the recirculation mode on. When the button is pressed, an indicator light in the button comes on. Press the button again to return to outside air mode. 3-21