2008 Chevrolet Aveo Owner's Manual - Page 176

Adjusting the Speakers (Balance/Fade) SOUND (Balance/Fade): To adjust the balance between the right and the left speakers, press this button until BAL (balance) displays. Turn the O knob to increase or to decrease. The display shows the balance level. After making the selection, press this button to set the balance level. To adjust the fade between the front and the rear speakers, press this button until FAD (fade) displays. Turn the O knob to increase or to decrease the fade between the front and the rear speakers. The display shows the fade level. After making the selection, press this button to set the fade level. Playing a CD Insert a CD partway into the slot, label side up. The player pulls it in and the CD should begin playing. When a CD is inserted, CDP displays. As the CD is loading, Filecheck displays. As each new track starts to play, Track and the track number displays. If the ignition or radio is turned off with a CD in the player, it stays in the player. When a CD is in the player and the ignition is turned on, the radio must be turned on before the CD starts playback. When the ignition and radio are turned on, the CD starts playing where it stopped, if it was the last selected audio source. The CD player can play the smaller 3 inch (8 cm) single CDs with an adapter ring. Full-size CDs and the smaller CDs are loaded in the same manner. If playing a CD-R, the sound quality can be reduced due to CD-R quality, the method of recording, the quality of the music that has been recorded, and the way the CD-R has been handled. There can be an increase in skipping, difficulty in finding tracks, and/or difficulty in loading and ejecting. If these problems occur, check the bottom surface of the CD. If the surface of the CD is damaged, such as cracked, broken, or scratched, the CD will not play properly. If the surface of the CD is soiled, see Care of Your CDs on page 3-79 for more information. If there is no apparent damage, try a known good CD. Setting the Equalization The order for displayed customized equalization settings are EQ OFF, CLASSIC, DANCE, ROCK, JAZZ, POP, VOICE, TECHNO, EQ OFF. SOUND (Equalization): Press this button until EQ OFF (equalization) displays to select customized equalization settings designed for classic, dance, rock, jazz, pop, voice and techno. Turn the O knob until the desired equalization setting displays. After making the selection, press the SOUND button to set the equalization setting. To cancel an equalization setting, press the SOUND button until EQ OFF displays, turn the O knob until OFF displays, then press the SOUND button again to set the equalization setting. 3-62