2008 Chevrolet Uplander Owner's Manual - Page 105

After your vehicle's engine has been started two times using the remote start button, the vehicle's ignition switch must be turned to ON/RUN and then back to LOCK/OFF using the key before the remote start procedure can be used again. After entering the vehicle during a remote start, insert and turn the key to ON/RUN to drive the vehicle. To manually shut off the engine after a remote start, do any of the following: The hazard warning flashers are on. There is an emission control system malfunction. The engine coolant temperature is too high. The oil pressure is low. Two remote vehicle starts have already been provided. The maximum number of remote starts or remote start attempts between ignition cycles with the key is two. • Aim the RKE transmitter at the vehicle and press the remote start button until the parking lamps turn off. Remote Start Ready If your vehicle does not have the remote vehicle start feature, it may have the remote start ready feature. This feature allows your dealer/retailer to add the manufacturer's remote vehicle start feature. If the RKE transmitter has a plus (+) symbol on the back cover, your vehicle has the remote start ready feature. You can lock or unlock your vehicle from approximately 197 feet (60 m) away. See your dealer/retailer if you would like to add the manufacturer's remote vehicle start feature to your vehicle. • Turn on the hazard warning flashers. • Insert the vehicle's key into the ignition switch and turn the switch to ON/RUN and then back to LOCK/OFF. The remote vehicle start feature will not operate if: • The remote start system is disabled. See "REMOTE START" under DIC Vehicle Personalization (Uplevel Only) on page 3-76. • The vehicle's key is in the ignition. • The vehicle's hood, liftgate or doors are not closed. 2-9