2008 Chevrolet Uplander Owner's Manual - Page 114

Your vehicle also has passenger power sliding door activation switch(es). Power Sliding Door Operation The power sliding door(s) will only open if the transaxle is in PARK (P). The transaxle does not have to be in PARK (P) to close the door(s). There are several ways to open and close the power sliding door(s). • If your vehicle has a single power sliding door, press the top of the overhead console PSD activation/ override (deactivation) switch. • If your vehicle has dual power sliding doors, press the top of the driver's side and/or passenger's side overhead console PSD activation/override (deactivation) switch. • Press the passenger PSD activation switch. This switch will also stop a moving door immediately. • Press the power sliding door button on the remote keyless entry transmitter. • To manually open the power sliding door(s) while the switch(es) are in the activation position, pull and release the inside or outside door handle to release the door latch. The door will fully open. • To manually close the power sliding door(s) while the switches are in the activation position, pull the inside or outside door handle or the edge of the door. Move the door about 4 inches (10 cm) toward the closed position and release it. The door will close completely and latch. Passenger PSD Activation Switch If you have a single PSD, this switch is located in front of the passenger side sliding door. If your vehicle has dual PSDs, the switches are located in front of both sliding doors. 2-18