2012 Chevrolet Tahoe Owner's Manual - Page 331
2012 Chevrolet Tahoe Manual
Page 331 highlights
Driving and Operating The cruise control light on the instrument panel cluster comes on after the cruise control has been set to the desired speed. 1. Press the Increasing Speed While Using Cruise Control If the cruise control system is already activated, . . 9-53 I button. To slow down in small amounts, press the SET- button on the steering wheel briefly. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) slower. 2. Get up to the desired speed. 3. Press the SET− button located on the steering wheel and release it. 4. Take your foot off the accelerator. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed reaches about 40 km/h (25 mph) or more, press the +RES button on the steering wheel. The vehicle returns to the previous set speed and stays there. . Press and hold the +RES button on the steering wheel until the desired speed is reached, then release it. To increase vehicle speed in small amounts, press the +RES button. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) faster. Passing Another Vehicle While Using Cruise Control Use the accelerator pedal to increase the vehicle speed. When you take your foot off the pedal, the vehicle will slow down to the previous set cruise speed. Using Cruise Control on Hills How well the cruise control works on hills depends on the vehicle speed, the load, and the steepness of the hills. When going up steep hills, pressing the accelerator pedal may be necessary to maintain vehicle speed. Reducing Speed While Using Cruise Control If the cruise control system is already activated, . Press and hold the SET- button on the steering wheel until the desired lower speed is reached, then release it.