2013 Chevrolet Silverado 1500 Crew Cab Owner Manual - Page 365
2013 Chevrolet Silverado 1500 Crew Cab Manual
Page 365 highlights
Driving and Operating headlamps as a second way to boost the vehicle system and charge the battery. Camper/Fifth-Wheel Trailer Wiring Package The seven-wire camper harness is located under the front edge of the pickup box on the driver side of the vehicle, attached to the frame bracket. A connector must be added to the wiring harness which connects to the camper. The harness contains the following camper/trailer circuits: . . 9-97 Electric Brake Control Wiring Provisions These wiring provisions are included with the vehicle as part of the trailer wiring package. These provisions are for an electric brake controller. The instrument panel contains blunt cut wires behind the steering column for the trailer brake controller. The harness contains the following wires: If the vehicle is equipped with the "Heavy-Duty Trailering" option, please refer to "Heavy-Duty Trailer Wiring Package" earlier in this section. When the camper-wiring harness is ordered without the heavy-duty trailering package, a seven-wire harness with a seven-pin connector is located at the rear of the vehicle and is tied to the vehicle's frame. . Dark Blue: Brake Signal to Trailer Connector Red/Black: Battery Light Blue/White: Brake Switch White: Ground ... Yellow: Left Stop/Turn Signal Dark Green: Right Stop/Turn Signal Brown: Taillamps White: Ground Light Green: Back-up Lamps Red: Battery Feed Dark Blue: Trailer Brake ... The harness should be installed by your dealer or a qualified service center. If the vehicle is equipped with an Integrated Trailer Brake Control (ITBC) System, the blunt cuts exist, but are not connected further in the harness. If an aftermarket trailer brake controller is installed, the