2013 Chevrolet Silverado 1500 Crew Cab Owner Manual - Page 440
2013 Chevrolet Silverado 1500 Crew Cab Manual
Page 440 highlights
10-64 Vehicle Care When installing dual wheels, check that the vent holes in the inner and outer wheels on each side are lined up. Adjust the front and rear tires to the recommended inflation pressure on the Tire and Loading Information label after the tires have been rotated. See Tire Pressure on page 10‑56 and Vehicle Load Limits on page 9‑15. Check that all wheel nuts are properly tightened. See "Wheel Nut Torque" under Capacities and Specifications on page 12‑2. WARNING (Continued) off and cause an accident. When changing a wheel, remove any rust or dirt from places where the wheel attaches to the vehicle. In an emergency, a cloth or a paper towel can be used; however, use a scraper or wire brush later to remove all rust or dirt. to another position, however, they can be rotated from left to right to the same position. Use this rotation pattern when rotating the tires if the vehicle has polished forged aluminum dual rear wheels. The spare wheel can be used in any position and can be rotated with the rear inner wheels. { WARNING Rust or dirt on a wheel, or on the parts to which it is fastened, can make wheel nuts become loose after time. The wheel could come (Continued) Lightly coat the center of the wheel hub with wheel bearing grease after a wheel change or tire rotation to prevent corrosion or rust build-up. Do not get grease on the flat wheel mounting surface or on the wheel nuts or bolts. Reset the Tire Pressure Monitor System (TPMS), if the vehicle has one. See Tire Pressure Monitor Operation on page 10‑59.