2014 Chevrolet Express 2500 Cargo Owner Manual - Page 160
2014 Chevrolet Express 2500 Cargo Manual
Page 160 highlights
7-8 Infotainment System Radio AM-FM Radio Radio Data System (RDS) The radio may have an RDS. The RDS feature is available for use only on FM stations that broadcast RDS information. This system relies upon receiving specific information from these stations and only works when the information is available. While the radio is tuned to an FM-RDS station, the station name or call letters display. In rare cases, a radio station could broadcast incorrect information that causes the radio features to work improperly. If this happens, contact the radio station. f (Tune): Turn clockwise or counterclockwise to increase or decrease the station frequency. © SEEK or ¨ SEEK: Press © SEEK to go to the previous or ¨ SEEK to go to the next station and stay there. To scan stations, press and hold either button for two seconds until a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. For AM-FM Radio and Radio with CD, the station frequency flashes while the radio is in the scan mode. Press either button again to stop scanning. The radio seeks and scans stations only with a strong signal that are in the selected band. For AM-FM Radio and Radio with CD, scan presets within the current selected band by pressing and holding either SEEK button for four seconds until a double beep sounds. The radio goes to a stored preset, plays for a few seconds if a strong signal is present, then goes to the next stored preset. The station frequency flashes while the radio is in the scan mode. Setting Preset Stations If the radio does not have a FAV button, up to 18 stations (six FM1, six FM2, and six AM), can be programmed on the six numbered softkeys, by performing the following steps: 1. Turn the radio on. 2. Press BAND to select FM1, FM2, or AM. 3. Tune in the desired station. 4. Press and hold one of the six numbered softkeys for three seconds until a beep sounds. When that softkey is pressed and released, the station that was set, returns. 5. Repeat Steps 2-4 for each softkey. Finding a Station BAND: Press to switch between FM1, FM2, AM, and XM. The selection displays.