2014 Chevrolet Express 2500 Cargo Owner Manual - Page 31
2014 Chevrolet Express 2500 Cargo Manual
Page 31 highlights
Keys, Doors, and Windows The RKE transmitter range may be less while the vehicle is running. There are other conditions which can affect the performance of the transmitter, see Remote Keyless Entry (RKE) System on page 2-2 for additional information. locked. The airbag readiness light will be on during a remote start. It should turn off when the ignition is turned to ON/RUN. See Airbag Readiness Light on page 5-15 for more information. The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once. After entering the vehicle during a remote start, insert and turn the key to ON/RUN to drive the vehicle. The maximum number of remote starts between ignition cycles with the key is two. If the remote start procedure is used again before the first 10 minute time frame has ended, the first 10 minutes will immediately expire and the second 10 minute time frame will start. After the engine has been remote started two times, the ignition switch must be turned to ON/RUN and then 2-5 back to LOCK/OFF using the key before the remote start procedure can be used again. To cancel a remote start do any of the following: . / (Remote Vehicle Start): This button will be on the RKE transmitter if you have remote start. To start the engine using the remote start feature: 1. Aim the RKE transmitter at the vehicle. 2. Press and release transmitter. Aim the RKE transmitter at the vehicle and press / until the parking lamps turn off. Turn on the hazard warning flashers. Turn the ignition on and then back off. . . Q on the The remote vehicle start feature will not operate if: ... The key is in the ignition. The hood is open. The hazard warning flashers are on. There is an emission control system malfunction. See Malfunction Indicator Lamp on page 5-19. The engine coolant temperature is too high. 3. Immediately press and hold / until the turn signal lamps flash. If you cannot see the vehicle's lamps, press and hold for four seconds. When the engine starts, the parking lamps will turn on and remain on while the engine is running. The doors will be . .