2014 Chevrolet Express 2500 Passenger Owner Manual - Page 146

6-2 Lighting To change the headlamps from low beam to high beam, pull the turn signal lever all the way toward you. Then release it. Headlamp High/ Low-Beam Changer 2 3 (Headlamp High/Low-Beam Changer): Pull the turn signal lever all the way toward you to change the headlamps from low to high beam. Then release it. Release the lever to turn the high-beam headlamps off. Exterior Lamps Off Reminder If a door is open, a reminder chime sounds when the headlamps or parking lamps are manually turned on and the key is out of the ignition. To turn off the chime, turn the headlamp switch to O or AUTO and then back on, or close and re‐open the door. In the auto mode, the headlamps turn off once the ignition is in LOCK/OFF or may remain on until the headlamp delay ends, if enabled in the Driver Information Center (DIC). See "Exit Lighting" under Vehicle Personalization on page 5-39. Daytime Running Lamps (DRL) DRL can make it easier for others to see the front of the vehicle during the day. Fully functional DRL are required on all vehicles first sold in Canada. The DRL system comes on in daylight when the following conditions are met: . This instrument cluster light comes on when the high-beam headlamps are on. The ignition is on. The exterior lamp control is in the AUTO position. The shift lever is not in P (Park). The light sensor determines it is daytime. . . Flash-to-Pass This feature is used to signal to the vehicle ahead that you want to pass. If the headlamps are off or in the low‐beam position, pull the turn signal lever toward you to momentarily switch to high beams. . When the DRL are on, the taillamps, sidemarker, instrument panel lights, and other lamps will not be on.