2014 Chevrolet Express 2500 Passenger Owner Manual - Page 148
2014 Chevrolet Express 2500 Passenger Manual
Page 148 highlights
6-4 Lighting When the hazard warning flashers are on, the vehicle's turn signals will not work. one second causes the turn signals to flash continually until the lever is released. The lever returns to its starting position when released. If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb may be burned out. Have any burned out bulbs replaced. If a bulb is not burned out, check the fuse. See Fuses and Circuit Breakers on page 10-40. wiper speed. When the wipers are not operating, these lamps turn off. Move the exterior lamp control to P or ; to disable this feature. Hazard Warning Flashers Turn and Lane-Change Signals G (Turn Signals): An arrow on the instrument cluster flashes in the direction of the turn or lane change. To signal a turn, move the lever all the way up or down. Turn Signal On Chime If the turn signal is left on for more than 1.2 km (0.75 mi), a chime sounds at each flash of the turn signal and the message TURN SIGNAL ON also appears in the Driver Information Center (DIC). See Lamp Messages on page 5-34. To turn off the chime and message, move the turn signal lever to the off position. | (Hazard Warning Flashers): Press this button to make the front and rear turn signal lamps flash on and off. This warns others that you are having trouble. Press again to turn the flashers off. To signal a lane change, raise or lower the lever until the arrow starts to flash. The turn signal automatically flashes three times and if the Tow/Haul Mode is active it flashes six times. Holding the turn signal lever for more than