2007 Chrysler Pacifica Owner's Manual - Page 157

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157 5. Press and hold the just trained HomeLink button and observe the indicator light or the EVIC display. If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink button is pressed and released. If the EVIC display shows "Channel X Transmit" (where X is Channel 1, 2, or 3), programming is complete and your device should activate when the HomeLink button is pressed and released. NOTE: To program the remaining two HomeLink buttons, begin with Programming Step Two. Do not repeat Step One. NOTE: If your hand-held transmitter appears to program the universal transceiver, but your garage door does not operate using the transmitter and your garage door opener was manufactured after 1995, your garage door opener may have a multiple security code system (rolling code system). If your garage door is the "rolling code" type, please proceed to the heading "Programming A Rolling Code System." Programming A Rolling Code System 1. At the garage door opener receiver (motor-head unit) in the garage, locate the learn or smart button. This can usually be found where the hanging antenna wire is attached to the motor-head unit. 2. Firmly press and release the learn or smart button. (The name and color of the button may vary by manufacturer.) NOTE: There are 30 seconds in which to initiate Step Three. 3