2007 Chrysler Pacifica Owner's Manual - Page 30

30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE This feature will not operate if there is any manual operation of the power door locks (Lock or Unlock). If desired, the "Auto Unlock On Exit?" feature can be turned on or off by using the following procedure: • On electronic vehicle information center (EVIC) equipped vehicles refer to "Auto Unlock On Exit?" under "Use Factory Settings?" in the EVIC section of this manual. • On non EVIC - equipped vehicles perform the following steps: Auto Unlock On Exit Programming 1. Enter your vehicle and close all doors. 2. Fasten your seat belt (fastening the seat belt will cancel any chimes that may be confusing during this programming procedure). 3. Insert the key into the ignition. 4. Within 15 seconds, cycle the key from the LOCK position to the ON/RUN position a minimum of four times ending in the LOCK position (do not start the engine). 5. Within 30 seconds, press the driver's door lock switch in the UNLOCK direction. 6. A single chime will sound to indicate the feature has been changed. 7. Repeat the above steps to alternate the availability of this feature. 8. If a chime is not heard, program mode was canceled before the feature could be changed. If necessary repeat the above procedure. NOTE: Use the Auto Door Locks and Auto Unlock features in accordance with local laws.