2012 Chrysler 200 Owner Manual - Page 201

UNDERSTANDING YOUR INSTRUMENT PANEL 199 The two trip odometers show individual trip mileage. To switch from odometer to trip odometers, press and release the Trip Odometer button. To reset a trip odometer, display the desired trip odometer to be reset then push and hold the button until the display resets (approximately 2 seconds). Refer to "Trip Odometer Button" for additional information. NOTE: If the instrument cluster is equipped with the optional Electronic Vehicle Information Center (EVIC), then warnings such as "Low Tire," "Door Ajar" and "Trunk Ajar" will display in the EVIC. (Refer to "Electronic Vehicle Information Center (EVIC)" for specific messages). LoW tirE Vehicle Odometer Messages When the appropriate condition exists, the odometer When the appropriate conditions exist, the odometer will display will toggle between LoW and tirE for three display the following messages: cycles. door ...Door Ajar dECK ...Trunk Ajar LoW tirE ...Low Tire Pressure CHANgE OIL...Oil Change Required gASCAP ...Fuel Cap Fault HOTOIL ...Engine Oil Temperature Exceeds Safe Threshold HOTOIL When this message is displayed there is a engine oil over-temperature condition. When this condition occurs, the "HOTOIL" message will be displayed in the odometer along with a chime. Refer to "If Your Engine Overheats" in "What To Do In Emergencies". 4