2013 Chrysler Town & Country User Guide - Page 104

2013 Chrysler Town & Country Manual

Page 104 highlights

W H AT TO D O I N E M E R G E N C I E S 3. Place the wrench on the jack screw and turn to the right until the jack head is properly engaged in the described location. Do not raise the vehicle until you are sure the jack is securely engaged. 4. Raise the vehicle by turning the jack screw to the right, using the swivel wrench. Raise the vehicle only until the tire just clears the surface and enough clearance is obtained to install the spare tire. Minimum tire lift provides maximum stability. 5. Remove the wheel lug nuts, for vehicles with wheel covers, remove the cover from the wheel by hand. Do not pry the wheel cover off. Then pull the wheel off the hub. 6. Install the compact spare tire. Lightly tighten the lug nuts. NOTE: • Do not install the wheel cover on the compact spare. • Do not use a hammer or force to install the wheel covers. 7. Lower the vehicle by turning the jack screw to the left. 8. Finish tightening the lug nuts. Push down on the wrench while at the end of the handle for increased leverage. Tighten the lug nuts in a star pattern until each nut has been tightened twice. The correct wheel nut tightness is 102 ft lbs (138 N·m). If in doubt about the correct tightness, have them checked with a torque wrench by your authorized dealer or at a service station. 9. Lower the jack to its fully-closed position. 10. Place the deflated (flat) tire and compact spare tire cover assembly in the rear cargo area. Do not stow the deflated tire in the spare tire location. Have the full-sized tire repaired or replaced, as soon as possible. 11. Stow the cable and wheel spacer before driving the vehicle. Reassemble the winch handle extensions to form a "T" and fit the winch T-handle over the drive nut. Rotate the nut to the right until the winch mechanism clicks at least three times. NOTE: Refer to the "Spare Tire Tools" section for instructions on assembling the T-handle. 12. Stow the jack, jack handle and winch handle tools back in the stowage compartment. 13. Check the compact spare tire pressure as soon as possible. Correct the tire pressure, as required. 102

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140

3. Placethewrenchonthejackscrewandturntotherightuntilthejackheadisproperlyengaged
inthedescribedlocation.
Donotraisethevehicleuntilyouaresurethejackissecurely
engaged.
4. Raisethevehiclebyturningthejackscrewtotheright,usingtheswivelwrench.Raisethe
vehicleonlyuntilthetirejustclearsthesurfaceandenoughclearanceisobtainedtoinstallthe
sparetire.Minimumtireliftprovidesmaximumstability.
5. Removethewheellugnuts,forvehicleswithwheelcovers,removethecoverfromthewheel
byhand.Donotprythewheelcoveroff.Thenpullthewheeloffthehub.
6. Installthecompactsparetire.Lightlytightenthelugnuts.
NOTE:
• Do not install the wheel cover on the
compactspare.
• Do not use a hammer or force to install
thewheelcovers.
7. Lowerthevehiclebyturningthejackscrew
totheleft.
8. Finishtighteningthelugnuts.Pushdownon
thewrenchwhileattheendofthehandlefor
increasedleverage.Tightenthelugnutsina
starpatternuntileachnuthasbeentightenedtwice.Thecorrectwheelnuttightnessis102
ftlbs(138N·m).Ifindoubtaboutthecorrecttightness,havethemcheckedwithatorque
wrenchbyyourauthorizeddealerorataservicestation.
9. Lowerthejacktoitsfully-closedposition.
10. Placethedeflated(flat)tireandcompactsparetirecoverassemblyintherearcargoarea.
Donotstowthedeflatedtireinthesparetirelocation.
Havethefull-sizedtirerepairedor
replaced,assoonaspossible.
11. Stowthecableandwheelspacerbeforedrivingthevehicle.Reassemblethewinchhandle
extensionstoforma“T”andfitthewinchT-handleoverthedrivenut.Rotatethenuttothe
rightuntilthewinchmechanismclicksatleastthreetimes.
NOTE:
Refertothe“SpareTireTools”sectionforinstructionsonassemblingtheT-handle.
12. Stowthejack,jackhandleandwinchhandletoolsbackinthestowagecompartment.
13. Check the compact spare tire pressure as soon as possible. Correct the tire pressure, as
required.
WHAT TO DO IN EMERGENCIES
102