2013 Chrysler Town & Country User Guide - Page 31

O P E R AT I N G YO U R V E H I C L E • Vehicles equipped with Blind Spot Monitoring will produce a visual alert and may be programmed to produce an audible alert when signaling a lane change; refer to your Owner's Manual on the DVD for operation. Front Wipers Intermittent, Low And High Operation • Rotate the end of the lever to the first detent position for one of five intermittent settings, the second detent for low wiper operation and the third detent for high wiper operation. Rain Sensing Wipers • This feature senses moisture on the vehicle's windshield and automatically activates the wipers for the driver when the switch is in the intermittent positions. Refer to Programmable Features in Electronics for further details. Mist • Push the end of the lever inward to the first detent when a single wipe is desired. NOTE: The mist feature does not activate the washer pump; therefore, no washer fluid will be sprayed on the windshield. The wash function must be activated in order to spray the windshield with washer fluid. Washer Operation • Push the end of the lever inward to the second detent and hold for as long as spray is desired. Rear Wiper • Rotate the center portion of the lever forward to the first detent for rear wiper operation. Rear Washer • Rotate the center portion of the lever past the first detent to activate the rear washer. High Beams • Push the lever away from you to activate the high beams. • A high beam symbol will illuminate in the cluster to indicate the high beams are on. NOTE: For safe driving, turn off the high beams when oncoming traffic is present to prevent headlight glare and as a courtesy to other motorists. Flash To Pass • Pull the lever toward you to activate the high beams. The high beams will remain on until the lever is released. 29