2014 Chrysler 300 User Guide - Page 14
2014 Chrysler 300 Manual
Page 14 highlights
G E T T I N G S TA R T E D To Enter The Trunk: • With a valid Keyless Enter-N-Go™ Key Fob located outside the vehicle and within 3 ft (1.0 m) of the deck lid, press the button on the located on the center of the light bar which is located on the deck lid above the license plate. NOTE: Refer to your Owner's Manual on the DVD for further information. Engine Starting/Stopping Starting • With a valid Keyless Enter-N-Go™ Key Fob inside the vehicle. • Shift the transmission to PARK or NEUTRAL. • While pressing the brake pedal, press the ENGINE START/STOP button once. If the engine fails to start, the starter will disengage automatically after 10 seconds. • To stop the cranking of the engine prior to the engine starting, press the button again. NOTE: In case the ignition switch does not change with the push of a button, the RKE transmitter (Key Fob) may have a low or dead battery. In this situation a back up method can be used to operate the ignition switch. Put the nose side of the Key Fob (side opposite of the Emergency Key) against the ENGINE START/STOP button and push to operate the ignition switch. Stopping 1. Bring the vehicle to a complete stop. 2. Shift the transmission to PARK (P). 3. Press the ENGINE START/STOP button once. The ignition switch will return to the OFF position. NOTE: If the transmission is not in PARK and the vehicle is in motion, the ENGINE START/STOP button must be held for two seconds with the vehicle speed above 5 mph (8 km/h) before the engine will shut off. 12