2014 Chrysler 300 User Guide - Page 90
2014 Chrysler 300 Manual
Page 90 highlights
W H AT TO D O I N E M E R G E N C I E S JUMP-STARTING • If your vehicle has a discharged battery it can be jump-started using a set of jumper cables and a battery in another vehicle or by using a portable battery booster pack. • Jump-starting can be dangerous if done improperly so please follow the procedures in this section carefully. NOTE: When using a portable battery booster pack follow the manufacturer's operating instructions and precautions. Preparations For Jump-Start • The battery is stored under an access cover in the trunk. Remote battery posts are located on the right side of the engine compartment for jump-starting. NOTE: The remote battery posts are viewed by standing on the right side of the vehicle looking over the fender. • Set the parking brake, shift the automatic transmission into PARK and turn the ignition to OFF. • Turn off the heater, radio, and all unnecessary electrical accessories. • If using another vehicle to jump-start the battery, park the vehicle within the jumper cables reach, set the parking brake and make sure the ignition is OFF. Jump-Starting Procedure 1. Connect the positive (+) end of the jumper cable to the remote positive (+) post of the discharged vehicle. 2. Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the booster battery. 3. Connect the negative end (-) of the jumper cable to the negative (-) post of the booster battery. 4. Connect the opposite end of the negative (-) jumper cable to the remote negative (-) post of the vehicle with the discharged battery. 5. Start the engine in the vehicle that has the booster battery, let the engine idle a few minutes, and then start the engine in the vehicle with the discharged battery. Once the engine is started, remove the jumper cables in the reverse sequence: 1. Disconnect the negative (-) jumper cable from the remote negative (-) post of the vehicle with the discharged battery. 88