2007 Dodge Dakota Owner Manual - Page 114
2007 Dodge Dakota Manual
Page 114 highlights
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink should now activate your rolling code equipped device. NOTE: To program the remaining two HomeLink buttons, begin with ЉProgrammingЉ step two. Do not repeat step one. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Canadian Programming/Gate Programming Canadian radio-frequency laws require transmitter signals to Љtime-outЉ (or quit) after several seconds of transmission which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to Љtime-outЉ in the same manner. If you live in Canada or you are having difficulties programming a gate operator by using the ЉProgrammingЉ procedures (regardless of where you live), replace ؆Programming HomeLink؆ step 3 with the following: NOTE: If programming a garage door opener or gate operator, it is advised to unplug the device during the ЉcyclingЉ process to prevent possible overheating. 3. Continue to press and hold the HomeLink button while you press and release every two seconds (ЉcycleЉ) your hand-held transmitter until the frequency signal has successfully been accepted by HomeLink. (The indicator light will flash slowly and then rapidly.) Proceed with ЉProgrammingЉ step four to complete. Using HomeLink To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting,