2009 Dodge Ram 1500 Pickup Owner Manual - Page 180
2009 Dodge Ram 1500 Pickup Manual
Page 180 highlights
178 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Gate Operator/Canadian Programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. has successfully accepted the frequency signal. The EVIC display will change from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." If you unplugged the device for training, plug it back in at this time. Then proceed with Step 4 under "Programming HomeLink" earlier in this section. It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage Using HomeLinkா To operate, simply press and release the programmed door or gate motor. HomeLink button. Activation will now occur for the If you are having difficulties programming a garage door trained device (i.e., garage door opener, gate operator, opener or a gate operator, replace "Programming security system, entry door lock, home/office lighting, HomeLink" Step 3 with the following: etc.) The hand-held transmitter of the device may also be 3. Continue to press and hold the HomeLink button used at any time. while you press and release - every two seconds ("cycle") your hand-held transmitter until HomeLink