2009 Dodge Ram 1500 Pickup Owner Manual - Page 34

32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Auto Unlock On Exit Programming - If Equipped 4. Within 15 seconds, cycle the key from the OFF position The Automatic Unlock Doors On Exit feature can be to the ON position a minimum of four times, ending in the OFF position. (Do not start the engine). enabled or disabled as follows: • For vehicles equipped with the EVIC, refer to "Unlock Doors If Driver Exits" under "CustomerProgrammable Features (SETUP)" in the "Electronic Vehicle Information Center (EVIC)," in Section 4 of this manual. 5. Within 30 seconds, press the driver's door UNLOCK switch. 6. A single chime will sound to indicate the feature has been changed. 7. Repeat the above steps to alternate the availability of • For vehicles not equipped with the EVIC, perform the this feature. following procedure: 8. If a chime is not heard, the program mode was 1. Enter your vehicle and close all doors. canceled before the feature could be changed. If neces2. Fasten your seat belt. (Fastening the seat belt will sary, repeat the above procedure. cancel any chimes that may be confusing during this programming procedure.) 3. Insert the key into the ignition.