2009 Dodge Ram 1500 Pickup Owner Manual - Page 313

STARTING AND OPERATING 311 If the engine has been flooded, it may start to run, but not have enough power to continue running when the key is released. If this occurs, continue cranking with the accelerator pedal pushed all the way to the floor. Release the accelerator pedal and the key once the engine is running smoothly. The engine block heater cord is routed under the hood on the passenger side of the vehicle near the right head lamp assembly. It is located between the front grill and the radiator, but underneath the black upper seal. It includes a removable cap that is secured by a tethered strap. It also has a c-clip that is used for storage when not If the engine shows no sign of starting after two 15- in use for the winter months. During winter months, second periods of cranking with the accelerator pedal remove the heater cord wiring assembly from itself on held to the floor, the "Normal Starting" procedure should the c-clip. be repeated. After Starting The idle speed is automatically controlled and will decrease as the engine warms up. ENGINE BLOCK HEATER - IF EQUIPPED The engine block heater warms the engine and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. 5 WARNING! Remember to disconnect the cord before driving. Damage to the 110-115 Volt electrical cord could cause electrocution.