2009 Dodge Ram 2500 Pickup Owner Manual - Page 157
2009 Dodge Ram 2500 Pickup Manual
Page 157 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 155 Your vehicle should be parked outside of the garage while training. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) from the HomeLink buttons while keeping the HomeLink display in view. For optimal training, point the battery end of the handheld transmitter away from the HomeLink. 3. Simultaneously, press and hold both the chosen HomeLinkbutton and the hand-held transmitter button until the indicator(s) change from a slow to a rapid flash rate. Then release both the HomeLink and hand-held transmitter buttons. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you train. If the signal is too weak to train, replace the battery in the original hand-held transmitter. NOTE: Some gate operators and garage door openers may require you to replace Step #3 with procedures noted in the "Gate Operator/Canadian Programming" section. 4. Press and hold the just-trained HomeLink button. If the indicator(s) blink rapidly for two seconds and then remains constant, continue with the next section: "Programming A Rolling Code System". NOTE: After training a HomeLink channel, if the garage door does not operate with HomeLink and the garage door opener was manufactured after 1995, the garage door opener may have rolling code. If so, proceed to the heading, "Programming A Rolling Code System." 3