2009 Dodge Ram 2500 Pickup Owner Manual - Page 31
2009 Dodge Ram 2500 Pickup Manual
Page 31 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 3. Place the key into the ignition. 4. Within 15 seconds, cycle the key from the LOCK position to the ON/RUN position a minimum of four times, ending in the ON/RUN position. (Do not start the engine). 5. Within 30 seconds, press the driver's door lock switch in the LOCK direction. 6. A single chime will be heard to indicate the feature has been disabled. 7. To reactivate this feature, repeat the above steps. 8. If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat the above procedure. Auto Unlock On Exit - If Equipped This feature unlocks all of the doors of the vehicle when any door is opened. This will occur only after the vehicle has been shifted into the PARK position after the vehicle has been driven (shifted out of PARK and all doors closed). Auto Unlock On Exit Programming - If Equipped Customer programming sequence to enable or disable the Auto Unlock on Exit feature: 1. Enter your vehicle and close all doors. 2. Fasten your seat belt. (Fastening the seat belt will cancel any chimes that may be confusing during this programming procedure.) 3. Insert the key into the ignition. 2