2009 Dodge Ram 2500 Pickup Owner Manual - Page 273

STARTING AND OPERATING 271 Alternate Procedure 1. Bring the vehicle to complete stop. 2. With the key ON and the engine either off or running, shift the transmission into NEUTRAL. 3. Rotate the transfer case control switch to the desired position. 4. After the desired "Transfer Case Position Indicator Light" is ON (not flashing), shift the transmission back into gear. NOTE: • If steps 1 or 2 of either the Preferred or Alternate Procedure are not satisfied, prior to attempting the shift, or if they no longer are being met while the shift attempt is in process, then the desired "Transfer Case Position Indicator Light" will flash continuously while the original "Transfer Case Position Indicator Light" is ON, until all requirements have been met. • The ignition key must be ON for a shift to take place and for the "Transfer Case Position Indicator Lights" to be operable. If the key is not ON, then the shift will not take place and no "Transfer Case Position Indicator Lights" will be on or flashing. • If your are leaving your vehicle stored for longer than 21 days, refer to the section on "Vehicle Storage." 5