2010 Dodge Nitro Owner Manual - Page 28

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27 • For security, power window and power sunroof op- To Exit Remote Start Mode without Driving the eration (if equipped) are disabled when the vehicle is Vehicle Press and release the REMOTE START button one time, in the Remote Start mode. or allow the engine to run for the entire 15-minute cycle. • The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, NOTE: To avoid unintentional shut downs, the system the ignition switch must be cycled to the ON position will disable the one time press of the REMOTE START before you can repeat the start sequence for a third button for two seconds after receiving a valid Remote Start request. cycle. Remote start will also cancel if any of the following occur: To Exit Remote Start Mode and Drive the Vehicle Before the end of the 15-minute cycle, press and release • The engine stalls or RPM exceeds 2500 the UNLOCK button on the RKE transmitter to unlock • Any engine warning lamps come on the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of the 15-minute cycle, • The hood is opened insert the key into the ignition switch and turn the switch • The hazard switch is pressed to the ON position. • The transmission is moved out of PARK • The brake pedal is pressed NOTE: The ignition switch must be in the ON position in order to drive the vehicle. 2