2013 Dodge Grand Caravan Passenger Owner Manual - Page 262

260 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAINING" button. This can usually be found where the hanging antenna wire is attached to the garage door opener/device motor. Firmly press and release the "LEARN" or "TRAINING" button. On some garage door openers/devices there may be a light that blinks when the garage door opener/device is in the LEARN/TRAIN mode. To program the remaining two HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. Programming A Non-Rolling Code For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. NOTE: You have 30 seconds in which to initiate the next 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) step after the LEARN button has been pressed. away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 6. Return to the vehicle and press the programmed HomeLink® button twice (holding the button for two 3. Simultaneously press and hold both the Homelink® seconds each time). If the garage door opener/device button you want to program and the hand-held transactivates, programming is complete. mitter button. NOTE: If the garage door opener/device does not activate, press the button a third time (for two seconds) to complete the training.