2013 Dodge Grand Caravan Passenger Owner Manual - Page 265

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 263 Reprogramming A Single HomeLink® Button Security To reprogram a channel that has been previously trained, It is advised to erase all channels before you sell or turn follow these steps: in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all 2. Press and hold the desired HomeLink® button until channels will be erased. Individual channels cannot be the indicator light begins to flash after 20 seconds. Do erased. not release the button. The HomeLink® Universal Transceiver is disabled when 3. Without releasing the button proceed with "Canadian/ the Vehicle Security Alarm is active. Gate Operator Programming" Step 2 and follow all Troubleshooting Tips remaining steps. 1. Cycle the ignition to the ON/RUN position. Using HomeLink® To operate, press and release the programmed HomeLink® button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any • Did you unplug the device for programming and remember to plug it back in? time. If you are having trouble programming HomeLink®, here are some of the most common solutions: • Replace the battery in the original hand-held transmitter. • Press the LEARN button on the Garage Door Opener to complete the training for a Rolling Code. 3