2013 Dodge Grand Caravan Passenger Owner Manual - Page 264

262 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Canadian radio frequency laws require transmitter sig- 4. Watch for the HomeLink® indicator to change flash nals to time-out (or quit) after several seconds of transrates. When it changes, it is programmed. It may take mission - which may not be long enough for HomeLink® up to 30 seconds or longer in rare cases. The garage to pick up the signal during programming. Similar to this door may open and close while you are programming. Canadian law, some U.S. gate operators are designed to 5. Press and hold the programmed HomeLink® button time-out in the same manner. and observe the indicator light. It may be helpful to unplug the device during the cycling • If the indicator light stays on constantly, programprocess to prevent possible overheating of the garage ming is complete and the garage door/device should door or gate motor. activate when the HomeLink® button is pressed. • To program the two remaining HomeLink® buttons, 1. Cycle the ignition to the ON/RUN position. repeat each step for each remaining button. DO NOT 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) erase the channels. away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. If you unplugged the garage door opener/device for programming, plug it back in at this time. 3. Continue to press and hold the HomeLink® button, while you press and release ("cycle"), your hand-held transmitter every two seconds until HomeLink® has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained.