2004 Ford Focus Owner Guide 2nd Printing - Page 41

Lights VOL (HID) 1. Park the vehicle on a level surface approximately 7.6 meters (25 feet) from a vertical wall or screen directly in front of it. 2. Measure the height of the headlamp bulb center from the ground, subtract 53.3 mm (2.1 inches), and make 2.5 meters (8 foot) horizontal reference line on the vertical wall or screen at this height. (A piece of masking tape works well.) 3. Open the hood. 4. Remove the battery cover. 5. Remove the headlamp bulb cover by releasing the four snap hooks (two top and two bottom). Note: On the left headlamp, pull the bulb cover approximately 1 inch rearward and then slide it out until the vertical aiming adjuster is accessible. 6. Turn on the low beam to illuminate the wall or screen. On the wall or screen you will observe an area of high intensity light. If the left side of each light pattern is not at the reference line, the beam needs to be adjusted. 7. The adjusting screw has a thumb wheel that can be operated by hand. Turn the aiming screw clockwise for upward movement and counterclockwise for downward movement. Note: HORIZONTAL AIMING IS NOT REQUIRED FOR THIS VEHICLE AND IS NON-ADJUSTABLE. 8. Turn off the headlamp. 9. Attach the headlamp bulb covers. 10. Attach the battery cover and close the hood. 41 2004 Focus (foc) Owners Guide (post-2002-fmt) USA English (fus)