2006 Ford Crown Victoria Owner Guide 2nd Printing - Page 48

Lights 6. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Replacing front parking lamp/turn signal bulbs The park/turn lamp bulbs can be replaced without removing the headlamp assembly. 1. Make sure headlamp switch is in the OFF position, then open the hood. 2. Remove the radiator cover by turning the three knobs to the unlock position. 3. Remove the screw from the outside of the lamp. 4. Remove the nut from inside the lamp and pull the lamp assembly forward. 5. Disconnect the electrical connector from the bulb by pulling rearward. 6. Rotate the bulb socket counterclockwise and remove from lamp assembly. 7. Carefully pull bulb straight out of the socket and push in the new bulb until it snaps, locking it into position. 8. To complete installation, follow the removal procedure in reverse order. Replacing tail lamp/brake/turn lamp bulbs The tail lamp, the brake lamp and the turn signal lamp bulbs are located in the tail lamp assembly. Follow the same steps to replace either bulb. 48 2006 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus)