2006 Ford Crown Victoria Owner Guide 2nd Printing - Page 88

Locks and Security 4. Insert the new battery. Refer to the diagram inside the remote entry transmitter for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 5. Snap the two halves back together. Note: Replacement of the battery will not cause the remote transmitter to become deprogrammed from your vehicle. The remote transmitter should operate normally after battery replacement. Replacing lost transmitters Take all your vehicle's transmitters to your authorized dealer if service is required. If a remote transmitter has been lost and you would like to remove it from the vehicle's memory, or you would like to purchase additional remote transmitters and have them programmed to your vehicle: • Take all your vehicle's transmitters to your authorized dealer for programming, or • Perform the following programming procedure yourself: Note: Ensure the brake pedal is not 3 depressed during this sequence. Place the key in the ignition and 2 cycle from 1 (OFF/LOCK) to 3 (ON) 4 eight times in rapid succession within 10 seconds. After doors lock/unlock, press any control on all transmitters (up to four). After 1 pressing the control on each remote transmitter, the door will lock and unlock. If programming multiple remote transmitters, you must press the control buttons on each remote transmitter within 7 seconds of each other to remain in programming mode. When completed, turn the ignition to 1 (OFF/LOCK). All transmitters must be programmed at the same time. • When completed, turn the ignition to the 1 (OFF/LOCK) position and wait at least 20 seconds in order to use the recently programmed transmitter(s). • All transmitters must be programmed during the same programming cycle. A transmitter that is not programmed within the same programming cycle will be erased and will no longer operate your 88 2006 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus)