2006 Ford Focus Owner Guide 4th Printing - Page 59

Locks and Security 4. Insert the new battery. Refer to the diagram inside the remote entry transmitter for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 5. Snap the two halves back together. Note: Replacement of the battery will not cause the remote transmitter to become deprogrammed from your vehicle. The remote transmitter should operate normally after battery replacement. Replacing lost remote entry transmitters If you would like to have your remote entry transmitter reprogrammed because you lost one, or would like to buy additional remote entry transmitters, you can either reprogram them yourself, or take all remote entry transmitters to your authorized dealer for reprogramming. How to reprogram your remote entry transmitters You must have all remote entry transmitters (maximum of four) available before beginning this procedure. To reprogram the remote entry transmitters: 1. Close all doors and fasten the driver's seat belt to ensure conflicting chimes do not sound during the procedure. 2. Put the key in the ignition. 3. Turn the key from the 2 (OFF) position to the 3 (ON) position. 4. Cycle four times rapidly (within six seconds) between the 2 (OFF) and the 3 (ON) position. Note: The fourth turn must end in the 2 (OFF) position. 5. Within 20 seconds press any button on the remote entry transmitter. Note: If more than 20 seconds have passed you will need to start the procedure over again. 6. Repeat Step 5 to program each additional remote entry transmitter. 7. Turn the ignition to the 3 (ON) position after you have finished programming all remote entry transmitters to exit programming mode. 59 2006 Focus (foc) Owners Guide (post-2002-fmt) USA (fus)