2007 Ford Mustang Owner Guide 1st Printing - Page 46

Lights Replacing backup bulbs The backup lamp is located in the tail lamp assembly. Follow the same steps to replace either bulb. 1. Make sure headlamp switch is in the OFF position, then open the trunk. 2. Carefully remove fasteners around the lamp area, then remove the interior trunk trim. 3. Disconnect the electrical connector by pulling it straight off of the lamp assembly. 4. Remove the three nut and washer assemblies and the lamp assembly from the vehicle. 5. Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. 6. Pull the bulb straight from the socket. Install the new bulb in reverse order. Replacing rear sidemarker lamp bulbs 1. Make sure the headlamp switch is in the OFF position and locate the sidemarker on the rear bumper fascia. 2. Install a flathead screwdriver between the rear of the sidemarker lens and the bumper fascia. 3. Push the screwdriver to the front of the vehicle and then slide it towards you to pop out the lens cover. 4. Carefully pull the bulb straight out of socket. Install the new bulb in reverse order. 46 2007 05+ Mustang (197) Owners Guide (post-2002-fmt) USA (fus)