2010 Ford Edge Scheduled Maintenance Guide 2nd Printing - Page 27
2010 Ford Edge Manual
Page 27 highlights
NORMAL SCHEDULE TRUCKS, FULLSIZE VANS & SUVS 150,000 miles ❑ Change engine oil and replace oil filter ❑ Change engine coolant (see Engine Coolant Change Interval on page 6 and Coolant Change Record on page 48) Replace cabin air filter (if equipped) Replace climate-controlled seat filter (if equipped) Replace engine air filter Replace fuel filter (except Escape, Mariner, F-Series [non Super Duty], Expedition/Navigator [short wheel base only], E-Series and Transit Connect) Change automatic transmission fluid and filter (filter not required on 6F35). (Except vehicles equipped with the TorqShift transmission). Change manual transmission fluid Change rear axle lubricant on all rear wheel drive (RWD) vehicles (see pages 41 and 47). Change transfer case fluid (4x4 only) Change front differential fluid (4x4 only) Replace wheel bearings (if non-sealed bearings) Replace accessory drive belt(s) if not replaced in the last 100,000 miles (160,000 km) Inspect steering linkage, ball joints, suspension, tie rod ends, driveshaft, and U-joints (lubricate if equipped with Zerk fittings) Torque the rear U-bolts (Transit Connect only) Inspect engine cooling system and hoses Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system. Inspect half shaft boots (if equipped) Inspect exhaust system and heat shields Inspect and lubricate 4x4 front axle U-joints Rotate tires, inspect tires for wear and measure tread depth Inspect the wheels and related components for abnormal noise, wear, looseness, or drag Perform multi-point inspection (recommended) DEALER VALIDATION: Normal Schedule Trucks, Fullsize Vans & SUVs RO#: DATE: P&A CODE: MILEAGE: Scheduled Maintenance 27 2010 Scheduled Maintenance Guide (smg) Scheduled Maintenance Guide, 2nd Printing USA (fus)