2012 Ford Transit Connect Owner Guide 1st Printing - Page 81
2012 Ford Transit Connect Manual
Page 81 highlights
Locks and Security How to reprogram your remote entry transmitters You must have all remote entry transmitters (maximum of four) available before beginning this procedure. If all remote entry transmitters are not present during the programming procedure, the transmitters that are not present during programming will no longer operate the vehicle. Note: Ensure the brake pedal is not depressed during this sequence. To reprogram the remote entry transmitters: 1. Ensure the vehicle is unlocked. 2. Put the key in the ignition in the 0 (off) position. 3. Cycle four times rapidly (within six seconds) between the 0 (off) and II (on) position. Note: The fourth turn must end in the II (on) position. 4. Turn the key to the 0 (off) position within 10 seconds. 5. A chime will sound to confirm that the programming mode has been activated. 6. Within 10 seconds press any button on the remote entry transmitter. Note: If more than 10 seconds have passed you will need to start the procedure over again. 7. A chime will sound to confirm that this remote entry transmitter has been programmed. 8. Repeat Step 6 to program each additional remote entry transmitter. 9. The programming mode will exit automatically after 10 seconds of inactivity, or by turning the ignition to position II. Illuminated entry The interior lamps illuminate when the remote entry system is used to unlock the door(s). The illuminated entry system will turn off the interior lights if: • the ignition switch is turned to the on position, or • the remote transmitter lock control is pressed, or • after 25 seconds of illumination. The dome lamp control (if equipped) must not be set to the off position for the illuminated entry system to operate. 81 PAGE POSITION: 81 JOB: @zeta.tweddle.com/ford_pdm/ford/own2002/835536-en-tst/og pubnum: