2013 Ford Expedition Owner Manual Printing 3 - Page 57

56 Keys and Remote Control Note: Your vehicle's keys were issued with a security label that provides important vehicle key cut information. Keep the label in a safe place for future reference. Replacing the Battery Note: Refer to local regulations when disposing of transmitter batteries. Note: Do not wipe off any grease on the battery terminals or on the back surface of the circuit board. Note: Replacing the battery will not delete the transmitter from your vehicle. The transmitter should operate normally. The remote control uses one coin-type three-volt lithium battery CR2032 or equivalent. Integrated Keyhead Transmitter 1. Twist a thin coin in the slot near the key 1 ring to remove the battery cover (1). 2. Carefully peel up the rubber gasket (2) 2 from the transmitter if it does not come off with the battery cover. 3 3. Remove the old battery (3). 4. Insert the new battery. Refer to the instructions inside the integrated keyhead transmitter for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 5. Reinstall the rubber gasket. 6. Snap the battery cover back onto the key. Memory Feature (If Equipped) The feature allows the remote control to recall the driver seat, power mirrors and power adjustable foot pedals memory positions. 2013 Expedition (exd) Owners Guide gf, 3rd Printing, April 2013 USA (fus)