2014 Ford Fiesta Owner Manual Printing 2 - Page 64
2014 Ford Fiesta Manual
Page 64 highlights
Security You must have two previously programmed coded keys and the new unprogrammed key readily accessible. See your authorized dealer to have the spare key programmed if two previously programmed coded keys are not available. Read and understand the entire procedure before you begin. 1. 2. Insert the first previously programmed coded key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds. Switch the ignition off and remove the first coded key from the ignition. After three seconds but within 10 seconds of switching the ignition off, insert the second previously coded key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds. Switch the ignition off and remove the second previously programmed coded key from the ignition. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed coded key, insert the new unprogrammed key into the ignition. Switch the ignition from off to on. Keep the ignition on for at least six seconds. Remove the newly programmed coded key from the ignition. Programming a Spare Intelligent Access Key See your authorized dealer to have additional keys programmed to your vehicle. ANTI-THEFT ALARM Alarm System The perimeter alarm is a deterrent against unauthorized access to your vehicle through the doors and the hood. It also protects the audio unit. 3. 4. Triggering the Alarm Once armed, the alarm is triggered in any of the following ways: • If someone opens a door, the liftgate or the hood without a valid key or remote control. If someone removes the audio or navigation system. If you switch the ignition on without a valid key. 5. • • 6. 7. If the alarm is triggered, the alarm horn will sound for 30 seconds and the hazard warning flasher will flash for five minutes. Any further attempts to perform one of the above will trigger the alarm again. 8. 9. Arming the Alarm To arm the alarm, lock your vehicle. See Locks (page 52). If the key has been successfully programmed it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If programming was not successful, wait 10 seconds and repeat Steps 1 through 8. If you are still unsuccessful, take your vehicle to your authorized dealer. Disarming the Alarm Vehicles Without Keyless Entry Disarm and silence the alarm by unlocking the doors with the key and switching the ignition on with a correctly coded key or unlocking the doors with the remote control. 61 Fiesta (CCT) Vehicles Built From: 01-04-2013, Vehicles Built Up To: 31-12-2013