2015 Ford Escape Owner Manual Printing 1 - Page 86
2015 Ford Escape Manual
Page 86 highlights
Windows and Mirrors MOONROOF (If Equipped) WARNINGS Do not let children play with the moonroof or leave them unattended in the vehicle. They may seriously hurt themselves. When closing the moonroof, you should verify that it is free of obstructions and make sure that children and pets are not in the proximity of the roof opening. The moonroof and sunscreen controls are located on the overhead console. The moonroof and sunscreen have a one-touch open and close feature. To stop them during one-touch operation, press the control a second time. Opening and Closing the Moonroof E138669 Press and release the rear of the control to open the moonroof. If it is closed, the sunscreen will automatically open before the moonroof opens. The moonroof will stop short of the fully opened position. Note: This position helps to reduce wind noise or rumbling which may happen with the moonroof fully open. Press and hold the control again to fully open the moonroof. Press and release the front of the control to close the moonroof. Opening and Closing the Sunscreen Bounce-Back The moonroof will stop automatically while closing. It will reverse some distance if there is an obstacle in the way. Press and hold the front of the control within two seconds of a bounce-back event to override this function. While bounce-back is active, the closing force increases for each of the next three times that you close the moonroof. E138668 Press and release the rear of the control to open the sunscreen. Press and release the front of the control to close the sunscreen. If it is open, the moonroof will automatically close before the sunscreen closes. Venting the Moonroof Press and release the front of the control to vent the moonroof. Press and release the rear of the control to close the moonroof. Note: When you vent the moonroof it will rise to 1.57 in (4 cm) and then lower slightly. This is normal. You cannot stop the moonroof in the higher position. 83 Escape (TM2), enUSA, First Printing