2015 Ford Mustang Owner Manual Printing 1 - Page 144
2015 Ford Mustang Manual
Page 144 highlights
Brakes WARNINGS Always set the parking brake fully and make sure that the transmission is securely latched in park (P) (automatic transmission) or first gear (1) (manual transmission). To set the parking brake, pull the parking brake handle up as far as possible. To release the parking brake: 1. Press and hold the button located at the end of the parking brake handle. 2. Pull the handle up slightly, then push the handle down. When the system is active, your vehicle will remain stationary on the slope for two to three seconds after you release the brake pedal. This allows you time to move your foot from the brake to the accelerator pedal. The brakes are released automatically once the engine has developed sufficient drive to prevent your vehicle from rolling down the slope. This is an advantage when pulling away on a slope, for example from a car park ramp, traffic lights or when reversing uphill into a parking space. The system will activate automatically on any slope that will cause significant vehicle rollback. For vehicles with a manual transmission, you can switch this feature off using the information display. See Information Displays (page 83). The system will remain on or off depending on how it was last set. HILL START ASSIST WARNINGS The system does not replace the parking brake. When you leave your vehicle, always apply the parking brake and shift the transmission into park (P) for automatic transmission or first gear for manual transmission. You must remain in your vehicle once you have activated the system. During all times, you are responsible for controlling your vehicle, supervising the system and intervening, if required. If the engine is revved excessively, or if a malfunction is detected, the system will be deactivated. The system makes it easier to pull away when your vehicle is on a slope without the need to use the parking brake. Using Hill Start Assist 1. Press the brake pedal to bring your vehicle to a complete standstill. Keep the brake pedal pressed. 2. If the sensors detect that your vehicle is on a slope, the system will activate automatically. 3. When you remove your foot from the brake pedal, your vehicle will remain on the slope without rolling away for about two or three seconds. This hold time will automatically be extended if you are in the process of driving off. 4. Drive off in the normal manner. The brakes will release automatically. 141 Mustang (), enUSA, First Printing