2015 Ford Mustang Owner Manual Printing 1 - Page 189

Convertible Top Using the Tonneau Caps Your convertible top also includes two tonneau caps, one for each side of the vehicle. These caps stow in a bag inside the trunk. To remove the tonneau caps: 1. Slide B toward the center of the vehicle to release the edges from the surrounding trim. 2. Lift up on B, and then pull the piece back to release A from the trim. 3. Repeat Steps 1 and 2 on the opposite side of the vehicle. 4. Make sure you stow both pieces in the trunk using the provided bag. E174569 A. B. Leading edge. Side edge. E179941 After opening your convertible top, place the tonneau caps between the top and your vehicle trim moulding: 1. Insert A under the trim. 2. When A is under the trim cap, angle B down so the edges slide under the surrounding moulding and secure into place between the trim edges. 3. Repeat Steps 1 and 2 on the opposite side of the vehicle to install the second tonneau cap. Note: The convertible top does not operate unless the vehicle is stationary or traveling under 3.0 mph (4.8 km/h). A chime sounds and a warning message appears in the instrument panel. When you slow down, the top operates. Note: You must remove the tonneau caps before you are able to close the top or a chime sounds and a warning message appears in the instrument panel. Remove and stow the caps, and then press the convertible top control again. Note: When you latch or unlatch the convertible top, the audio system mutes briefly. This allows the vehicle to optimize the cabin's sound quality depending on the position of the convertible top. CLOSING THE CONVERTIBLE TOP Closing the convertible top is a three-step process: Remove both of the tonneau caps, press the convertible top control to close the top, and then close the latch. 186 Mustang (), enUSA, First Printing