2015 Ford Transit Connect Passenger Owner Manual Printing 1 - Page 119
2015 Ford Transit Connect Passenger Manual
Page 119 highlights
Starting and Stopping the Engine To lock the steering wheel: 1. Remove the key from the ignition switch. 2. Rotate the steering wheel slightly to engage the lock. To unlock the steering wheel: 1. Insert the key in the ignition switch. 2. Turn the key to position I. Note: You may need to rotate the steering wheel slightly to assist unlocking if there is a steering wheel load applied. Note: You can only operate the starter for a limited period of time, for example 10 seconds. The number of start attempts is limited to approximately six. If you exceed this limit, the system will not allow you to try again until a period of time has elapsed, for example 30 minutes. Engine Idle Speed after Starting The speed at which the engine idles immediately after starting will adjust automatically to minimize vehicle emissions and maximize cabin comfort and fuel economy. The idle speed will vary depending on certain factors. These include vehicle component and ambient temperatures as well as electrical and climate system demands. STARTING A GASOLINE ENGINE Before starting the engine check the following: Make sure all occupants have fastened their safety belts. Make sure the headlamps and electrical accessories are off. Make sure the parking brake is on. Make sure the transmission is in park (P). Cold or Hot Engine If the engine does not start within 10 seconds, wait for a short period and try again. If the engine does not start after three attempts, wait 10 seconds and follow the flooded engine procedure. If you have difficulty starting the engine when the temperature is below -13°F (-25°C), press the accelerator pedal to the mid-way point of its travel and try again. When you start the engine, the idle speed increases, this helps to warm up the engine. If the engine idle speed does not slow down automatically, have your vehicle checked by an authorized dealer. Note: Do not touch the accelerator pedal. 1. Fully press the brake pedal. 2. Turn the ignition key to position II to switch the ignition on. 3. Turn the ignition key to position III to start your vehicle. Release the key when the engine starts. Flooded Engine 1. Move the transmission selector lever to position P. 2. Fully depress the accelerator pedal and hold it there. 3. Start the engine. Note: If the engine does not start, repeat the cold or hot engine procedure. 116 Transit Connect (CHC) Canada/United States of America, enUSA, First Printing