1998 Honda CR-V Owner's Manual - Page 119

Audio System Operating the Radio The ignition switch must be in ACCESSORY (I) or ON (II) to operate the audio system. Turn the system on by pushing the PWR/ VOL knob. Adjust the volume by turning the same knob. The band and frequency that the radio was last tuned to is displayed. To change bands, press the A M / F M 1-2 button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction on AM is not available. You can use any of three methods to find radio stations on the selected band: TUNE, SEEK, or the Preset buttons. TUNE - Use the TUNE bar to tune the radio to a desired frequency. Press the side of the bar to tune to a higher frequency, and the side to tune to a lower frequency. The frequency numbers will start to change rapidly. Release the bar when the display reaches the desired frequency. To change the frequency in small increments, press and release the TUNE bar quickly. SEEK - The SEEK function searches the band for a station with a strong signal. To activate it, press the SEEK bar on either the or side, then release it. Depending on which side you press, the system scans upward or downward from the current frequency. It stops when it finds a station with a strong signal. Preset - You can store the frequencies of your favorite radio stations in the six preset buttons. Each button will store one frequency on the AM band, and two on the FM band. Comfort and Convenience Features