2006 Hummer H2 Owner's Manual - Page 380
2006 Hummer H2 Manual
Page 380 highlights
Taillamps, Turn Signal, Stoplamps and Back-up Lamps A. Stoplamp/Taillamp B. Turn Signal Lamp C. Back-Up Lamp 3. Remove the two screws from the rear lamp assembly and remove the rear lamp assembly. 4. Turn the bulb socket counterclockwise to remove it from the taillamp housing. To replace one of these bulbs, do the following: 1. Open the liftgate or tailgate. See Liftgate (SUV) on page 2-11 or Tailgate/Spare Tire Carrier on page 2-14 for more information. 2. If your vehicle is equipped with a taillamp guard, you will need to remove it in order to access the taillamp. To do this, remove the four screws retaining the taillamp guard making sure not to remove the plastic retainers. 5. Pull the bulb straight out from the socket. 6. Press a new bulb into the socket, insert it into the taillamp housing and turn the socket counterclockwise until it is locked in place. 7. Reinstall the rear lamp assembly and tighten the screws. 8. Reinstall the taillamp guard by lining up the guard with the holes in vehicle. Then install and tighten the four screws. 5-50